Page 1 of 1

Add RPD Function

Posted: Thu Aug 15, 2019 4:33 pm
by Shikarego
Add a fourth layer option: All.
This would lay the selected pipe in all 3 layers at once.

Clicking around pipes you've already lain is pretty miserable. This would speed up the construction of cooling loops and such.

Just a little QOL addition.

I suspect this would be easy to add, but I've never coded in Byond so please correct me.

Re: Add RPD Function

Posted: Thu Aug 15, 2019 8:57 pm
by Ghilker
If you do that, there should be also the option to select only two layers, since you can lay out only two layers at the same time like 1 and 2, 2 and 3 or 1 and 3

Most of times I only have to work with 2 layers at the same time, so it should be a selectable function

Re: Add RPD Function

Posted: Thu Aug 15, 2019 11:33 pm
by Shikarego
Ghilker wrote:If you do that, there should be also the option to select only two layers, since you can lay out only two layers at the same time like 1 and 2, 2 and 3 or 1 and 3

Most of times I only have to work with 2 layers at the same time, so it should be a selectable function

OOH I LIKE THAT A LOT

Yeah so maybe make it so you can select multiple layers at a time? Without the addition of a button?

In any case, good point.