Anonmare wrote:What's everyone's favourite SM gas mixes?
I personally use 66% N2O and 33% O2 as I've found it a good compromise between power and stability. I know there are more power efficient mixes though, there was one guy who made this complicated mix but I don't remember what the percentages were but it had CO2, plasma, O2 and N2O and he got some really incredible power outage with full room temp plasma tanks.
If the Freon dissipation is still disabled, then Freon Breeding Reactor. Freon + energy = more freon. How can you not love that?
Alternatively, I'll put some of the mixes I came up with when coding this nonsense. Keep in mind, I have not played in a month or two or three because I'm kinda busy so they might work slightly different since you guys changed the processing speed so keep that in mind.
Low pressure, pure oxygen: Low pressure mixes do stuff a bit differently, and a lot of people overlook them. Due to the very low amounts of oxygen in the chamber, the plasma waste will actually end up making up a significant percentage of the mix count as plasma. So depending on how little gas you have in the chamber and how fast you siphon it, you might end up with 10%-60% plasma in the mix, even though you're running a pure oxygen setup. And that's extremely power efficient and extremely easy to cool. However, if the vents ever get clogged or if you move the gas too slowly, this mix goes bad extremely fast.
High Pressure, warm 50% N2O and 50% Oxygen: This is a good mix to learn hot setups. You want to run this at around 3x the amount of K that room temperature is, whatever that amount is. How do you keep this setup just warm enough but not too warm and not too cold? That's for you to figure out. Get creative and start repiping stuff. It is a very good idea to run this setup at high pressures, since those lose/gain heat much slower which makes it much easier to keep a consistant temperature.
20% CO2, 80% N2: A good starting point for the charge inertia chain reactions. Why would you run this as a non traitor? I don't know, plenty of CEs ran stage 4 singulos too. It's dangerous. It's fun. It makes stupid amounts of powers and kills everyone if you make a tiny mistake. Consider turning off some emitters for this setup. If you manage to get CO2 high, you might even want to turn off all emitters, since the crystal will produce just enough from its own heat. By the way, too much power damages the crystal directly, but you can stabilize that to a certain point by cooling the crystal enough so even these setups can end up stable.
70% Plasma, 30% CO2: Probably the weirdest setup, it resembles an oversized turbine. You cannot run this with the normal chamber, you have to move stuff around and replace some walls with spacetiles and possibly add other venting methods. The idea is that you mix this in atmos and then pipe it into the supermatter chamber. It creates absurdly high amounts of waste gas so you will want to vent it straight into space.